DTC B1579 Voice Recognition Microphone Disconnected |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1579 | Telephone microphone signal is lost. |
|

| 1.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 5 (MIC-) - Body ground | Always | Below 1 Ω |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY [TELEPHONE MICROPHONE ASSEMBLY]) |
Disconnect the K32 navigation receiver assembly connector.
Disconnect the W7 roof console box assembly (telephone microphone assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K32-1 (SNS2) - W7-14 (SNS2) | Always | Below 1 Ω |
| K32-5 (MIN-) - W7-8 (MCO-) | Always | Below 1 Ω |
| K32-1 (SNS2) - Body ground | Always | 10 kΩ or higher |
| K32-5 (MIN-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 14 (SGND) - 8 (MIC-) | Always | Below 1 Ω |
| Result | Proceed to |
| OK (for Column Shift Type) | A |
| OK (for Floor Shift Type) | B |
| NG (for Short Type Overhead Console Box) | C |
| NG (for Long Type Overhead Console Box) | D |
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||