Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Clearance Warning ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit is the power source circuit to operate the clearance warning ECU assembly.

WIRING DIAGRAM


E280652E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY - BATTERY AND BODY GROUND)


    B156356E03
  1. Disconnect the back sonar or clearance sonar switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J125-6 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J125-7 (E) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Back Sonar or Clearance Sonar Switch Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY
  1. Remove the back sonar or clearance sonar switch assembly (Click here).

  1. Inspect the back sonar or clearance sonar switch assembly (Click here).



NG
REPLACE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY AND BODY GROUND)
  1. Disconnect the J35 clearance warning ECU assembly connector.

  1. Disconnect the J125 back sonar or clearance sonar switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J35-11 (IG) - J125-3 (ECU)
    Always
    Below 1 Ω
    J35-11 (IG) - Body ground
    Always
    10 kΩ or higher
    J35-16 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)