Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > ABS Warning Light does not Come ON

for Preparation Click here


WIRING DIAGRAM

Refer to ABS Warning Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

1.INSPECT CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (ABS WARNING LIGHT)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Select the Active Test mode and operate the ABS warning light using the Techstream.

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    ABS Warning Light
    ABS warning light
    ON / OFF
    Observe combination meter

  1. Check that the ABS warning light turns on and off in the combination meter when using the Techstream.

    OK:
    The ABS warning light turns on and off in accordance with the Techstream operation.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE VSC ACTUATOR ASSEMBLY (Click here)