Home › ENGINE ยท 1GR-FE › COOLING › WATER PUMP

WATER PUMP > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FOR COOLANT LEAK

HINT:
  1. The sliding surface inside the water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the drain plug or the bottom of the water pump assembly. Engine coolant may leak if foreign matter enters the water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces.
  2. Before performing this inspection, check that there is no coolant leaking from any parts other than the engine water pump assembly. If there are leaks, inspect those areas.
  3. Perform this inspection when the engine is cold.

  1. Visually check the water pump assembly.

    1. Check that engine coolant is not dripping from the water pump assembly.

      HINT:
      1. If engine coolant is dripping, replace the water pump assembly.
      2. If engine coolant is not dripping, perform the following check.



  1. Inspect the area around the water pump assembly.

    HINT:
    Check for deposits around the drain plug of the water pump assembly.


    1. Remove the fan shroud (Click here).



    2. A226460E01
    3. Press a piece of paper towel against the drain plug or deposits on the lip of the drain plug and check that the paper towel is not wet.
      Text in Illustration 
      *1
      Drain Plug
      If the paper towel is wet, replace the water pump assembly.
      If the paper towel is not wet, thoroughly clean the area around the water pump assembly.



2. INSPECT WATER PUMP ASSEMBLY


    A226461
  1. Turn the pulley and check that the water pump bearing moves smoothly and quietly.
    If necessary, replace the water pump assembly.

  1. Turn the pulley and check that the water pump bearing moves smoothly and quietly.
    If necessary, replace the water pump assembly.



3. INSPECT FLUID COUPLING ASSEMBLY


    A237563
  1. Remove the 4 nuts and fan from the fluid coupling.



    A224914
  1. Check the turning smoothness of the fluid coupling.
    If necessary, replace the fluid coupling assembly.



    A237564
  1. Check the fluid coupling for damage or silicon oil leaks.
    If necessary, replace the fluid coupling assembly.

  1. Install the fan with the 4 nuts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Install the fan shroud (Click here).