Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch

for Preparation Click here


DESCRIPTION

  1. If the manual UP/DOWN function does not operate, there may be a malfunction in the power window regulator switch assembly, the front passenger side motor, or the harness or connector.

WIRING DIAGRAM


B233012E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK LIN COMMUNICATION SYSTEM
  1. Check for LIN communication system DTCs related to the power window control system (Click here).

    OK:
    LIN communication system DTCs are not output.



NG
GO TO LIN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK FOR DTC (B2312)
  1. Check if DTC B2312 is output (Click here).

    OK:
    DTC B2312 is not output.



NG
GO TO DTC (B2312) (Click here)
OK


3.READ VALUE USING TECHSTREAM (FRONT PASSENGER SIDE MOTOR)
  1. Use the Data List to check if the front passenger side motor is functioning properly.

    P-Door Motor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    P Door P/W Up SW
    Front passenger side power window manual UP switch signal / ON or OFF
    ON: Power window regulator switch assembly operated
    OFF: Power window regulator switch assembly not operated
    -
    P Door P/W Down SW
    Front passenger side power window manual DOWN switch signal / ON or OFF
    ON: Power window regulator switch assembly operated
    OFF: Power window regulator switch assembly not operated
    -

    OK:
    The Techstream display changes normally when power window regulator switch assembly is operated.



NG
Go to step 4
OK

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (Click here)  

4.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - BODY GROUND)


    B184452E07
  1. Disconnect the M10 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M10-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (FRONT PASSENGER SIDE MOTOR - BATTERY AND BODY GROUND)


    B180291E14
  1. Disconnect the M11 motor connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    M11-2 (B) - Body ground
    Always
    11 to 14 V

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M11-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - FRONT PASSENGER SIDE MOTOR)


    B184455E16
  1. Disconnect the M10 switch connector.

  1. Disconnect the M11 motor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M10-6 (UP) - M11-10 (UP)
    Always
    Below 1 Ω
    M10-7 (DOWN) - M11-7 (DOWN)
    Always
    Below 1 Ω
    M10-6 (UP) - Body ground
    Always
    10 kΩ or higher
    M10-7 (DOWN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


7.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B231347E04
  1. Remove the power window regulator switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (UP) - 1 (GND)
    Manual UP operation
    Below 1 Ω
    7 (DOWN) - 1 (GND)
    Manual DOWN operation
    Below 1 Ω
    6 (UP) - 1 (GND)
    Not operated
    10 kΩ or higher
    7 (DOWN) - 1 (GND)
    Not operated
    10 kΩ or higher



NG
REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (Click here)
OK

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (Click here)