DTC C2174/74 Vehicle Speed Signal Malfunction |
DTC C2191/91 Vehicle Speed Signal Error (Test Mode DTC) |
| DTC Code | Detection Condition | Trouble Area |
| C2174/74 | Vehicle speed signal malfunction |
|
| C2191/91 | Test mode procedure is performed |
|

| 1.READ VALUE USING DATA LIST (VEHICLE SPEED) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check that the values indicated on the Techstream and on the combination meter are the same.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed | Vehicle speed/ min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) | Almost same as actual vehicle speed | Speed indicated on combination meter |
|
| ||||
| OK | |
| 2.CHECK DTC |
Perform a driving test.
Check for DTCs.
| Result | Proceed to |
| DTC C2174 is not output | A |
| DTC C2174 is output | B |
|
| ||||
| A | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (ECU - COMBINATION METER) |
Disconnect the J31 tire pressure warning ECU connector.
![]() |
Disconnect the J28 meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J31-2 (SPD) - J28-29 (+S) | Always | Below 1 Ω |
| J31-2 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - SKID CONTROL ECU) |

Disconnect the A17 skid control ECU connector.
Disconnect the J28 meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A17-3 (SP1) - J28-30 (SI) | Always | Below 1 Ω |
| A17-3 (SP1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK DTC (SFI SYSTEM) |
Check for DTCs.
| Result | Proceed to |
| DTC P0500 is not output | A |
| DTC P0500 is output | B |
|
| ||||
| A | |
| 6.REPLACE TIRE PRESSURE WARNING ECU |
Replace the tire pressure warning ECU (Click here).
| NEXT | |
| 7.PERFORM REGISTRATION OF TRANSMITTER ID |
Perform registration (Click here).
| NEXT | |
| 8.PERFORM INITIALIZATION |
Perform initialization (Click here).
| NEXT | |
| 9.CHECK DTC |
Perform a driving test.
Check for DTCs.
| Result | Proceed to |
| DTC C2174 is output | A |
| DTC C2174 is not output | B |
|
| ||||
| A | ||
| ||