Home › RESTRAINTS › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


DESCRIPTION

The combination meter assembly illuminates, blinks or turns off the seat belt warning light on the combination meter assembly in accordance with the state of the front seat inner belt assembly LH.

HINT:
The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat.


WIRING DIAGRAM


B289103E17


INSPECTION PROCEDURE

NOTICE:
The seat belt warning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure (Click here).

1.CHECK DTC (AIRBAG SYSTEM)
  1. Clear DTCs (Click here).

  1. Recheck for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO AIRBAG SYSTEM (Click here)
A


2.READ VALUE USING TECHSTREAM (DRIVER BUCKLE SW)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / SRS Airbag / Data List.

  1. Read the Data List according to the display on the Techstream.

    SRS Airbag (Center Airbag Sensor Assembly) 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Driver Buckle SW
    Driver buckle switch / Unset, Set or NG
    Unset: Seat belt not fastened
    Set: Seat belt fastened
    NG: Data is not determined
    -
    Result 
    Result
    Proceed to
    Unset or Set is displayed on the Techstream screen according to the driver seat belt condition
    A
    Unset or Set is not displayed normally on the Techstream screen according to the driver seat belt condition
    B
    NG is displayed on the Techstream screen (for Column Shift Type)
    C
    NG is displayed on the Techstream screen (for Floor Shift Type)
    D



B
REPLACE FRONT SEAT INNER BELT ASSEMBLY LH (Click here)

C
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)

D
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
A


Go to step 4

3.REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
  1. Replace the main body ECU (driver side junction block assembly) with a new one.


NEXT


4.CHECK SEAT BELT WARNING LIGHT
  1. Check the operation of the seat belt warning light (Click here).

    OK:
    The seat belt warning light operates normally.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

END (MAIN BODY ECU [DRIVER SIDE JUNCTION BLOCK ASSEMBLY] WAS DEFECTIVE)