DIFFERENTIAL CARRIER ASSEMBLY (for 1GR-FE, 1UR-FE) > REMOVAL |
| 1. REMOVE REAR WHEEL |
| 2. REMOVE PROPELLER SHAFT ASSEMBLY |
Remove the propeller shaft for 2WD (Click here).
Remove the propeller shaft for 4WD (Click here).
| 3. DRAIN DIFFERENTIAL OIL |
Stop the vehicle on a level place.
for Front Differential:
Using a 10 mm hexagon wrench, remove the filler plug and gasket.
Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.
Using a 10 mm hexagon wrench, install a new gasket and the drain plug.
for Rear Differential:
Remove the filler plug and gasket.
Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
| 4. REMOVE REAR AXLE SHAFT LH |
Remove the rear axle shaft LH (Click here).
| 5. REMOVE REAR AXLE SHAFT RH |
| 6. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY |
![]() |
Remove the 10 nuts, 10 washers and differential carrier.
Remove the gasket.