Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › CONDENSER

CONDENSER > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



2. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE FRONT BUMPER COVER
(Click here)


5. DISCONNECT OIL COOLER HOSE (w/ Air Cooled Transmission Oil Cooler)


    E188044
  1. Using pliers, grip the claws of the clip and slide the clip.

  1. Disconnect the 2 oil cooler hoses.



6. REMOVE RADIATOR ASSEMBLY
for 1GR-FE: (Click here)
for 1UR-FE: (Click here)
for 3UR-FE: (Click here)
for 3UR-FBE: (Click here)


7. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    E187984E05
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser assembly.
    Text in Illustration 
    *A
    w/o Air Cooled Transmission Oil Cooler
    *B
    w/ Air Cooled Transmission Oil Cooler

    NOTICE:
    1. When removing the bolt, do not allow any tools to contact the pipe.
    2. When removing the bolt, hold a part of the pipe near the connector.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



8. DISCONNECT AIR CONDITIONER TUBE ASSEMBLY


    E186078
  1. Remove the 2 bolts and air conditioner tube assembly from the cooler condenser assembly.

    NOTICE:
    1. When removing the bolt, do not allow any tools to contact the pipe.
    2. When removing the bolt, hold a part of the pipe near the connector.

  1. Remove the O-ring from the air conditioner tube assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



9. REMOVE COOLER CONDENSER ASSEMBLY
  1. Remove the 2 bolts.



    E283113E01
  1. Remove the cooler condenser assembly as shown in the illustration.
    Text in Illustration 
    *A
    w/o Air Cooled Transmission Oil Cooler
    *B
    w/ Air Cooled Transmission Oil Cooler



10. REMOVE COOLER DRYER


    I030086E01
  1. Using a 14 mm hexagon socket wrench, remove the cap from the modulator.



    I032475E01
  1. Remove the O-ring from the cap.



    E050386E01
  1. Using pliers, remove the cooler dryer.