Home › TRANSMISSION ยท AB60E AUTOMATIC TRANSMISSION › OIL COOLER (w/ Trailer Towing System)

OIL COOLER (w/ Trailer Towing System) > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER ASSEMBLY
  1. Remove the front bumper (Click here).



2. DISCONNECT NO. 1 OIL COOLER INLET HOSE AND NO. 1 OIL COOLER OUTLET HOSE


C162130E01
  1. Remove the bolt and move the water by-pass pipe so that the 2 oil cooler hoses can be disconnected.

  1. Disconnect the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose from the transmission oil thermostat.

  1. Disconnect the 2 hoses from the oil cooler tube to remove them.

    NOTICE:
    When disconnecting the hoses from the tube, support the tube by hand and be careful to prevent the tube from being deformed.



3. REMOVE OIL COOLER ACCESSORY ASSEMBLY


    C209363
  1. Disconnect the 2 hoses from the No. 2 oil cooler tube.

    NOTICE:
    When disconnecting the hoses from the tube, support the tube by hand and be careful to prevent the tube from being deformed.

  1. Detach the claw to open the No. 1 flexible hose clamp.

  1. Disconnect the 2 hoses from the oil cooler tube and remove the oil cooler accessory assembly.

    NOTICE:
    When disconnecting the hoses from the tube, support the tube by hand and be careful to prevent the tube from being deformed.



4. REMOVE OIL COOLER TUBE


C161349
  1. Remove the 2 bolts and oil cooler tube.



5. REMOVE COOLER CONDENSER ASSEMBLY (AIR COOLED OIL COOLER)
  1. Remove the cooler condenser (Click here).



6. REMOVE NO. 2 OIL COOLER TUBE


    C209366E01
  1. Disconnect the No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose from the cooler condenser.

  1. Remove the bolt and No. 2 oil cooler tube together with the 2 oil cooler hoses.

  1. Remove the No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose from the No. 2 oil cooler tube.