VEHICLE STABILITY CONTROL SYSTEM > Brake Warning Light does not Come ON |
| 1.INSPECT CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (BRAKE WARNING LIGHT) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select the Active Test mode and operate the BRAKE warning light using the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Brake Warning Light | Brake warning light | ON / OFF | Observe combination meter |
Check that the BRAKE warning light turns on and off in the combination meter using the Techstream.
|
| ||||
| OK | ||
| ||