Home › BRAKE › BRAKE › BRAKE BOOSTER

BRAKE BOOSTER > REMOVAL

for Preparation Click here


NOTICE:
Release the vacuum from the booster by depressing the brake pedal several times. then remove the brake master cylinder sub-assembly from the brake booster assembly.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



4. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
  1. Remove the brake master cylinder (Click here).



5. DISCONNECT VACUUM HOSE ASSEMBLY
  1. Slide the clip and disconnect the vacuum hose from the check valve.



6. DISCONNECT BRAKE BOOSTER CONNECTOR
  1. Disconnect the 2 brake booster connectors from the brake booster.



7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Remove the lower No. 1 instrument panel airbag assembly (Click here).



8. REMOVE PUSH ROD PIN
  1. Remove the clip and push rod pin.



9. REMOVE BRAKE BOOSTER ASSEMBLY


    C208550
  1. Remove the 4 nuts, and then pull out the brake booster.

  1. Remove the brake booster gasket from the brake booster.

  1. Loosen the lock nut and then remove the clevis.



10. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY