DTC C1310/11 Open or Short in Active Brake Booster Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1310/11 | Open or short in active brake booster solenoid circuit. |
|

| 1.CHECK BRAKE BOOSTER ASSEMBLY |
![]() |
Disconnect the A18 booster connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 (BST) - 4 (BSTP) | Always | 1.1 to 1.7 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - ACTIVE BRAKE BOOSTER) |
![]() |
Confirm that the skid control ECU connector and active brake booster connector are properly connected.
Disconnect the A17 ECU connector.
Disconnect the A18 booster connector.
Inspect both the connector case and the terminal for deformation and corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A17-31 (BST) - A18-3 (BST) | Always | Below 1 Ω |
| A17-31 (BST) - Body ground | Always | 10 kΩ or higher |
| A17-17 (BSTP) - A18-4 (BSTP) | Always | Below 1 Ω |
| A17-17 (BSTP) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||