Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM


E280972E03


INSPECTION PROCEDURE

1.CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY


    E225824E44
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J141-1 (MUTE) - Body ground
    Ignition switch ACC, audio system playing
    → Changing modes
    Above 3.5 V
    → Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Stereo Component Amplifier Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the J135 navigation receiver assembly connector.

  1. Disconnect the J141 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J135-16 (MUT1) - J141-1 (MUTE)
    Always
    Below 1 Ω
    J135-16 (MUT1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)
  1. Disconnect the navigation receiver assembly connector.



    E221772E24
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J135-16 (MUT1) - Body ground
    Ignition switch ACC, audio system is playing
    Above 3.5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Navigation Receiver Assembly)
    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)