SFI SYSTEM > ACIS Control Circuit |


| 1.PERFORM ACTIVE TEST USING TECHSTREAM (OPERATE VSV FOR ACIS) |
![]() |
Disconnect the vacuum hose from port F on the vacuum switching valve (for ACIS).
Connect the Techstream to the DLC3.
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Active the VSV for Intake Control.
Operate the VSV for ACIS.
Check the VSV air flow when switching the VSV.
| Test Condition | Specified Condition |
| VSV is ON | Air from port E flows out through port F |
| VSV is OFF | Air from port E flows out through air filter |
|
| ||||
| OK | |
| 2.CHECK VACUUM HOSES (VACUUM SWITCHING VALVE - INTAKE AIR CONTROL VALVE, INTAKE MANIFOLD) |
|
| ||||
| OK | |
| 3.INSPECT INTAKE MANIFOLD (INTAKE AIR CONTROL VALVE) |
Inspect the intake air control valve (Click here).
|
| ||||
| OK | ||
| ||
| 4.INSPECT VACUUM SWITCHING VALVE (FOR ACIS) |
Inspect the vacuum switching valve (for ACIS) (Click here).
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (VACUUM SWITCHING VALVE - ECM AND INTEGRATION RELAY) |
Remove the EFI NO. 2 fuse from the engine room relay block.
Check the EFI NO. 2 fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| EFI NO. 2 fuse | Always | Below 1 Ω |
Reinstall the EFI NO. 2 fuse.
Disconnect the D62 intake air control valve connector.
Disconnect the D74 ECM connector.
Remove the integration relay from the engine room relay block .
Disconnect the 1B integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D62-2 - D74-62 (ACIS) | Always | Below 1 Ω |
| D62-1 - 1B-4 | Always | Below 1 Ω |
| D62-2 or D74-62 (ACIS) - Body ground | Always | 10 kΩ or higher |
| D62-1 or 1B-4 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||