Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING ECU
  1. Install the tire pressure warning ECU with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    1. Avoid any impact to the tire pressure warning ECU.
    2. Do not drop the tire pressure warning ECU. If it is dropped, replace it with a new one.



2. INSTALL CLEARANCE WARNING ECU WITH BRACKET


    B354801
  1. Install the clearance warning ECU with bracket with the nut and bolt.

  1. Connect the ECU connectors and attach the harness clamp.

    NOTICE:
    Do not apply excessive force to the wire harnesses.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
(Click here)


4. REGISTRATION OF TRANSMITTER ID
  1. Register the transmitter ID (Click here).



5. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Be sure to inflate all tires to the proper inflation pressure before initialization.



6. CHECK TIRE PRESSURE AFTER REPAIRS
  1. After repairs, confirm that the actual tire pressures are displayed in the DATA LIST (Click here).