DTC P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance |
| DTC Code | DTC Detection Condition | Trouble Area |
| P2772 | Transfer indicator switch (L4) remains on while the vehicle is being driven under the following conditions for 1.8 sec. or more (1-trip detection logic): (a) Output shaft speed is between 1000 and 3000 rpm. (b) Transfer position switch is in 2WD or 4H. |
|
| Related DTCs | P2772: Transfer indicator switch/Functional check |
| Required sensors/Components | Transfer indicator switch |
| Frequency of operation | Continuous |
| Duration | ON malfunction (A): 1.8 seconds ON malfunction (B): 0.5 seconds |
| MIL operation | 1 driving cycle |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | P0500 (Output speed sensor circuit) P0722 (Vehicle speed sensor circuit) |
| Transfer neutral position switch | OFF |
| Output speed (Transfer output speed) | 1000 to 3000 rpm |
| Output speed (Transfer output speed) | 143 rpm or more |
| Transfer indicator switch (L4) | ON |
| Actual transfer gear ratio Transfer input speed/Transfer output speed | 0.9 or more, and less than 1.1 |

| 1.CHECK TRANSFER INDICATOR SWITCH |
![]() |
Disconnect the D70 transfer indicator switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D70-2 (L4) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Transfer Indicator Switch) |
|
| ||||
| OK | ||
| ||
| 2.CHECK 4 WHEEL DRIVE CONTROL ECU |
![]() |
Disconnect the D70 transfer indicator switch connector.
Disconnect the A26 4 wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-13 (L4) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to 4 Wheel Drive Control ECU) |
|
| ||||
| OK | ||
| ||
| 3.CHECK ECM |
![]() |
Disconnect the D70 transfer indicator switch connector.
Disconnect the A26 4 wheel drive control ECU connector.
Disconnect the A24 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-21 (L4) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
| OK (for 3UR-FE) | A |
| OK (for 3UR-FBE) | B |
| NG | C |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
|
| ||||
| A | ||
| ||