Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH


  1. for Manual Seat:



      B356070E01
    1. Install the front seat inner belt assembly LH with the nut.

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

      NOTICE:
      Do not allow the anchor of the front seat inner belt assembly LH to overlap the protruding part of the separate type front seat cushion spring assembly.

      Text in Illustration 
      *1
      Protruding Part

    2. Attach the wire harness clamp.



    3. B354554E01
    4. Connect the connector and attach the connector clamp and 3 wire harness clamps.
      Text in Illustration 
      *1
      Connector Clamp
      *2
      Wire Harness Clamp

    5. Attach the 2 hooks of the separate type front seat cushion cover.



  1. for Power Seat:



      B356091E01
    1. Install the front seat inner belt assembly LH with the nut.

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

      NOTICE:
      Do not allow the anchor of the front seat inner belt assembly LH to overlap the protruding part of the separate type front seat cushion spring assembly.

      Text in Illustration 
      *1
      Protruding Part

    2. Attach the wire harness clamp and connect the connector.



    3. B354885E01
    4. Attach the connector clamp and 3 wire harness clamps.
      Text in Illustration 
      *1
      Connector Clamp
      *2
      Wire Harness Clamp



2. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH


    B356071E01
  1. Install the front seat inner belt assembly RH with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor of the front seat inner belt assembly RH to overlap the protruding part of the separate type front seat cushion spring assembly.

    Text in Illustration 
    *1
    Protruding Part

  1. Connect the connector and attach the connector clamp.



3. INSTALL FRONT SEAT CUSHION SHIELD LH (for Manual Seat, for Driver Side)


    B354552E01
  1. Attach the 2 claws, clip and guide as indicated by the arrows in the order shown in the illustration to install the front seat cushion shield LH.

  1. Install the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Connect the 2 rubber bands.



4. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat, for Driver Side)
  1. Attach the claw to install the reclining adjuster release handle LH.



5. INSTALL FRONT SEAT ASSEMBLY (for Power Seat)
(Click here)


6. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)
(Click here)


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. CHECK SRS WARNING LIGHT
(Click here)