Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Regular Cab)

FRONT SEAT OUTER BELT ASSEMBLY (for Regular Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



3. REMOVE FRONT SEAT ASSEMBLY
  1. for Manual Seat:
    (Click here)

  1. for Power Seat:
    (Click here)



4. REMOVE FRONT DOOR SCUFF PLATE LH


B165843
  1. Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.



5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
  1. Partially remove the front door opening trim weatherstrip so that the lower quarter trim panel assembly can be removed .



6. REMOVE UPPER BACK PANEL GARNISH


B164740
  1. Detach the 10 clips and remove the upper back panel garnish.



7. REMOVE LUGGAGE COMPARTMENT BOX LH


B164747
  1. Remove the 2 clips.

  1. Detach the 3 claws and remove the luggage compartment box LH.



8. REMOVE LUGGAGE COMPARTMENT BOX RH


B164748
  1. Remove the 4 clips and luggage compartment box RH.



9. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY LH (for LH Side)


    B165729
  1. Detach the 2 claws and remove the cover.



    B165728
  1. Loosen the bolt and disconnect the front seat outer belt assembly LH.



    B165710
  1. Detach the 7 clips and remove the quarter trim panel assembly LH.



10. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY RH (for RH Side)


B164750
  1. Detach the 2 claws and remove the cover.



    B164749
  1. Loosen the bolt and disconnect the front seat outer belt assembly RH.



    B355510
  1. Push the 2 locks and remove the trim cover.

  1. Remove the jack assembly.



    B355511
  1. Detach the 9 clips and remove the lower quarter trim panel assembly RH.



11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH


    B165727
  1. Using a screwdriver, detach the 2 claws and open the shoulder belt anchor cover.

    HINT:
    Tape the screwdriver tip before use.



    B165726
  1. Loosen the bolt and disconnect the front seat outer belt assembly LH.



    B166604
  1. Disconnect the pretensioner connector as shown in the illustration.



    B166605
  1. Remove the 2 bolts and front seat outer belt assembly LH.