FRONT SEAT OUTER BELT ASSEMBLY (for CrewMax) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT SEAT ASSEMBLY |
for Manual Seat:
Remove the front seat (Click here).
for Power Seat:
Remove the front seat (Click here).
| 4. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.
| 5. REMOVE REAR DOOR SCUFF PLATE |
![]() |
Detach the 6 claws and 2 clips, and remove the rear door scuff plate LH.
| 6. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP |
Partially remove the front door opening trim weatherstrip so that the center lower pillar garnish and center pillar garnish can be removed.
| 7. REMOVE LOWER CENTER PILLAR GARNISH |
![]() |
Detach the 2 claws and remove the cover.
![]() |
Remove the bolt and seat belt anchor.
![]() |
Detach the 7 clips and 2 claws, and remove the pillar garnish.
| 8. REMOVE CENTER PILLAR GARNISH |
Using a screwdriver, detach the 2 claws and open the 2 assist grip covers.
Remove the 2 bolts and rear assist grip assembly from the center pillar garnish LH.
Remove the bolt.
Detach the clip, guide and remove the center pillar garnish LH.

| *1 | Protective Tape | - | - |
Pass the front seat outer belt assembly LH through the hole of the center pillar garnish LH.
| 9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the nut and shoulder anchor.
![]() |
Disconnect the pretensioner connector as shown in the illustration.
![]() |
Remove the 2 bolts and seat belt.