Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
Either condition is met:
  1. "ECM (Engine)" is not displayed on the "Bus Check" screen.
  2. "ECM Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside ECM
  2. ECM

WIRING DIAGRAM


C289527E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND)


  1. Disconnect the A24 and D74 ECM connectors.


    C234869E13


    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)
    -
    -

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D74-42 (E02) - Body ground
    Always
    Below 1 Ω
    D74-43 (E01) - Body ground
    Always
    Below 1 Ω
    D74-81 (E1) - Body ground
    Always
    Below 1 Ω
    D74-82 (ME01) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A24-1 (BATT) - Body ground
    Always
    11 to 14 V
    A24-2 (+B2) - Body ground
    Battery positive (+) voltage applied to terminal A24-34 (MREL)
    11 to 14 V
    A24-3 (+B) - Body ground
    Battery positive (+) voltage applied to terminal A24-34 (MREL)
    11 to 14 V
    A24-28 (IGSW) - Body ground
    Ignition switch ON
    11 to 14 V

    Result 
    Result
    Proceed to
    OK (for 1GR-FE)
    A
    OK (for 1UR-FE)
    B
    OK (for 3UR-FE)
    C
    OK (for 3UR-FBE)
    D
    NG
    E



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)

E
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE ECM (Click here)