Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)

DTC    B1442/42    Air Inlet Damper Control Servo Motor Circuit

for Preparation Click here


DESCRIPTION

The air inlet damper servo motor sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air inlet damper to any position, which controls the intake air settings (FRESH, FRESH / RECIRCULATION and RECIRCULATION).

HINT:
Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.


DTC Code
DTC Detection Condition
Trouble Area
B1442/42
Air inlet damper position sensor value does not change even if air conditioning amplifier operated air inlet damper servo motor
  1. Air inlet servo motor
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM


E147168E02


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (AIR INLET DAMPER TARGET PULSE)
  1. Use the Data List to check if the air inlet servo motor is functioning properly.

    Air Conditioner 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Air Inlet Damper Targ Pulse
    Air inlet damper target pulse /
    Min.: 0, Max.: 255
    REC: 7
    FRS: 28
    -

    OK:
    The display is as specified in the normal condition.

    Result 
    Result
    Proceed to
    OK (Checking from the DTC)
    A
    OK (Checking from the PROBLEM SYMPTOMS TABLE)
    B
    NG
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
A


2.REPLACE AIR INLET SERVO MOTOR
  1. Temporarily replace the air inlet servo motor with a new one (Click here).

    HINT:
    Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new one and check that the condition returns to normal.


NEXT


3.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC is not output.



NG
Go to step 4
OK

END (AIR INLET SERVO MOTOR IS DEFECTIVE) 

4.REPLACE AIR CONDITIONING HARNESS
  1. Replace the air conditioning harness.


NEXT


5.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC again (Click here).

    OK:
    DTC is not output.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END (AIR CONDITIONING HARNESS IS DEFECTIVE)