DTC B279A Theft Deterrent System Communication Line High Fixation |
| DTC Code | DTC Detection Condition | Trouble Area |
| B279A | When communication line (EFIO-IMI) between ECM and transponder key ECU is stuck on HI output for 6 seconds or more |
|

| 1.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Check for DTC (Click here).
| Result | Proceed to |
| DTC B279A is output | A |
| DTC B279A and other DTCs are output | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM) |
![]() |
Disconnect the J26 ECU connector.
Disconnect the A24 ECM connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J26-13 (EFIO) - A24-40 (IMI) | Always | Below 1 Ω |
| J26-13 (EFIO) or A24-40 (IMI) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| J26-13 (EFIO) - Body ground | Always | Below 1 V |
| A24-40 (IMI) - Body ground |
|
| ||||
| OK | |
| 4.CHECK TRANSPONDER KEY ECU (OUTPUT) |
![]() |
Measure waveform.
| Terminal No. (Symbols) | Tool Setting | Switch Condition |
| J26-13 (EFIO) - J26-16 (GND) | 10 V/DIV., 100 msec./DIV. | Ignition switch ON |
| Result | Proceed to |
| Waveform is not output normally | A |
| Waveform is output normally (for 1GR-FE) | B |
| Waveform is output normally (for 1UR-FE) | C |
| Waveform is output normally (for 3UR-FE) | D |
| Waveform is output normally (for 3UR-FBE) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 5.CHECK TRANSPONDER KEY ECU (POWER SOURCE AND BODY GROUND) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J26-1 (+B) - J26-16 (GND) | Always | 11 to 14 V |
|
| ||||
| OK | ||
| ||