Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY


    B166456E01
  1. Attach the 5 hooks (A).

  1. Attach the 5 hooks (B) and install the front passenger airbag on the instrument panel.



    B166454
  1. Install the 2 screws.

  1. Connect the 2 connectors and install the instrument panel wire to the front passenger airbag.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT
  1. Install the No. 1 side defroster nozzle duct with the 2 screws <E>.



3. INSTALL NO. 2 HEATER TO REGISTER DUCT
  1. Install the No. 2 heater to register duct with the 8 screws <E>.



4. INSTALL DEFROSTER NOZZLE ASSEMBLY


B355378
  1. Install the defroster nozzle assembly with the 3 screws <E>.

  1. Connect the No. 1 side defroster nozzle duct and No. 2 side defroster nozzle duct to the defroster nozzle assembly.



5. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY

HINT:
  1. Refer to the procedures from "INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (for Column Shift Type) (Click here).
  2. Refer to the procedures from "INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (for Floor Shift Type) (Click here).



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



7. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).