Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SEAT POSITION SENSOR

SEAT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SEAT POSITION AIRBAG SENSOR


    C107067E19
  1. Using a 1.0 mm (0.0393 in.) feeler gauge, temporarily install the seat position airbag sensor.
    Text in Illustration 
    *1
    1.0 mm
    *2
    Seat Position Airbag Sensor
    *3
    Feeler Gauge
    *4
    Seat Rail

    NOTICE:
    1. If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.
    2. When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

    HINT:
    Be sure that the clearance between the seat position airbag sensor and the seat rail is within 0.6 to 1.4 mm (0.0236 to 0.0551 in.).

  1. Using a T30 "TORX" socket wrench, tighten the "TORX" screw to install the seat position airbag sensor.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Make sure that the clearance between the seat position airbag sensor and the seat rail is within 0.6 to 1.4 mm (0.0236 to 0.0551 in.).

  1. Connect the connector.

  1. Check that there is no looseness in the installation parts of the seat position airbag sensor.



2. INSTALL FRONT SEAT CUSHION SHIELD LH (for Manual Seat)


    B354552E01
  1. Attach the 2 claws, clip and guide as indicated by the arrows in the order shown in the illustration to install the front seat cushion shield LH.

  1. Install the 3 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Connect the 2 rubber bands.



3. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)
  1. Attach the claw to install the reclining adjuster release handle LH.



4. INSTALL FRONT SEAT ASSEMBLY LH
  1. for Manual Seat:
    (Click here)

  1. for Power Seat:
    (Click here)



5. CHECK SRS WARNING LIGHT
(Click here)