Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SEAT POSITION SENSOR

SEAT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT SEAT ASSEMBLY LH
  1. for Manual Seat:
    (Click here)

  1. for Power Seat:
    (Click here)



2. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)
  1. Raise the reclining adjuster release handle LH to reveal the claw.



    B354549E01
  1. Using a screwdriver, detach the claw and remove the reclining adjuster release handle LH.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



3. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat)


    B354550
  1. Disconnect the 2 rubber bands.



    B354551E01
  1. Remove the 3 screws.

  1. Detach the guide, clip and 2 claws as indicated by the arrows in the order shown in the illustration to remove the front seat cushion shield LH.



4. REMOVE SEAT POSITION AIRBAG SENSOR


    B355987
  1. for Manual Seat:

    1. Disconnect the connector.

    2. Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor.



    B355989
  1. for Power Seat:

    1. Disconnect the connector.

    2. Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor.