Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › OCCUPANT CLASSIFICATION ECU

OCCUPANT CLASSIFICATION ECU > INSTALLATION

for Preparation Click here



1. INSTALL OCCUPANT CLASSIFICATION ECU
  1. Check that the ignition switch is OFF.

  1. Check that the cable is disconnected from the battery negative (-) terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  1. Attach the claw and install the occupant detection ECU to the front seat assembly RH.

    NOTICE:
    1. If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that there is no looseness in the installation parts of the occupant classification ECU.



2. INSTALL FRONT SEAT ASSEMBLY RH
  1. for Manual Seat:
    (Click here)

  1. for Power Seat:
    (Click here)