Home › BODY › SEAT › FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)

FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) > Front Power Seat does not Operate with Front Power Seat Switch

for Preparation Click here


DESCRIPTION

When a signal is input into the position control ECU and switch assembly, the ECU manages the signals received from the power seat switches, and operates each motors. If the position control ECU and switch assembly receives more than 2 motors operation signals, the motor is stopped. Manual operation is restarted after the position control ECU and switch assembly receives 1 signal only.

WIRING DIAGRAM


B226313E12


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK FRONT POWER SEAT OPERATION
  1. Check that each function of the power seat operates normally by using the power seat switches (Click here).
    Result 
    Result
    Proceed to
    All power seat functions does not operate
    A
    One or more power seat functions does not operate
    B



B
Go to OTHER FLOW CHART (One or more Power Seat Motors do not Operate) (Click here)
A


2.CHECK HARNESS AND CONNECTOR (POSITION CONTROL ECU AND SWITCH ASSEMBLY - BATTERY AND BODY GROUND)


    B307043E03
  1. Disconnect the Z9 and Z10 position control ECU and switch assembly connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Z9-7 (+B1) - Body ground
    Always
    11 to 14 V
    Z10-12 (SYSB) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Z9-2 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY (Click here)