Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > Key Reminder Buzzer does not Sound

for Preparation Click here


DESCRIPTION

The key reminder warning buzzer sounds when the driver side door is opened while the ignition switch is in the LOCK or ACC position. The key reminder warning buzzer is activated when the main body ECU sends a key switch signal and driver side courtesy switch signal to the combination meter.

HINT:
Since the key reminder warning system has functions that use CAN communication, first confirm that there is no malfunction in the communication system by inspecting the CAN communication function in accordance with the "HOW TO PROCEED WITH TROUBLESHOOTING" procedures. Then, conduct the following inspection procedure.


WIRING DIAGRAM


B205678E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (FRONT DOOR COURTESY SWITCH LH)
  1. Check the Data List for proper functioning of the front door courtesy light switch LH.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Front door courtesy light switch LH signal / ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -

    OK:
    The display is as specified in the normal condition column.



NG
GO TO LIGHTING SYSTEM (Click here)
OK


2.READ VALUE USING TECHSTREAM (UNLOCK WARNING SWITCH)
  1. Check the Data List for proper functioning of the unlock warning switch.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Unlock Warning SW
    Unlock warning switch signal /ON or OFF
    ON: Key is in ignition key cylinder
    OFF: No key is in ignition key cylinder
    -

    OK:
    ON (Key is in ignition key cylinder) appears on the screen.



NG
Go to step 3
OK

REPLACE MAIN BODY ECU 

3.INSPECT UNLOCK WARNING SWITCH ASSEMBLY
E146811E02
  1. Remove the unlock warning switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    10 kΩ or higher
    Pushed
    Below 1 Ω



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - MAIN BODY ECU AND BODY GROUND)
E145440E01
  1. Disconnect the J18 switch connector.

  1. Disconnect the J1 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J18-1 - J1-5 (KSW)
    Always
    Below 1 Ω
    J18-2 - Body ground
    Always
    10 kΩ or higher
    J1-5 (KSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK COMBINATION METER ASSEMBLY (OPERATION)
  1. Temporarily replace the combination meter assembly with a new or normally functioning one (Click here).

  1. Check the key reminder warning system function.

    OK:
    The key reminder warning system functions properly.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

END (COMBINATION METER IS DEFECTIVE)