METER / GAUGE SYSTEM > Voltage Meter Malfunction |

| 1.INSPECT FUSE (MET) |
Remove the MET fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| MET fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (VOLTMETER) |
Operate the Techstream according to the display and select "Active Test" (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Volt Meter Operation | Voltmeter | OFF, 0V, 3V, 6V, 9V, 12V, 15V or 18V | Perform the test with the vehicle stopped and engine idling |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the J28 meter connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J28-24 (ES) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| J28-2 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch OFF | Below 1 V |
|
| ||||
| OK | ||
| ||