Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA

RADIO ANTENNA > REMOVAL

for Preparation Click here



1. REMOVE PULL TOP ANTENNA POLE SUB-ASSEMBLY
(Click here)


2. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. for Column Shift Type:
    (Click here)

  1. for Floor Shift Type:
    (Click here)



5. REMOVE ANTENNA ORNAMENT


B355092
  1. Remove the antenna ornament as shown in the illustration.



6. REMOVE SIDE STEP ASSEMBLY RH (w/ Side Step)

HINT:
Use the same procedure described for the LH side.



7. REMOVE FRONT FENDER MUDGUARD RH (w/ Front Fender Mudguard)


B355062
  1. Remove the clip.

  1. Remove the 3 screws and front fender mudguard LH.



8. REMOVE FRONT FENDER LINER RH


    B355061
  1. Remove the 4 screws and clip.



    B355031
  1. Remove the 13 grommets and front fender liner RH.



9. REMOVE FENDER ANTENNA ASSEMBLY


    B355093
  1. Disconnect each connector.

  1. Remove the bolt and detach the 5 clamps.



    B355094
  1. Remove the bolt and fender antenna assembly.