Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION ANTENNA

NAVIGATION ANTENNA > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. for Column Shift Type:
    (Click here)

  1. for Floor Shift Type:
    (Click here)



4. REMOVE NO. 2 HEATER TO REGISTER DUCT


  1. Remove the 8 screws <E> and No. 2 heater to register duct.


    B355382



5. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT


    B355380
  1. Remove the 2 screws <E> and No. 2 side defroster nozzle duct.



6. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT


    B355379
  1. Remove the 2 screws <E> and No. 1 side defroster nozzle duct.



7. REMOVE DEFROSTER NOZZLE ASSEMBLY


B355377
  1. Disconnect the No. 1 side defroster nozzle duct and No. 2 side defroster nozzle duct from the defroster nozzle assembly.

  1. Remove the 3 screws <E> and defroster nozzle assembly.



8. REMOVE NAVIGATION ANTENNA ASSEMBLY


  1. Detach the 2 clamps.


    B353894E01


    Text in Illustration 
    *a
    Guide
    *b
    Clamp

  1. Remove the 2 screws.

  1. Detach the 2 guides and remove the navigation antenna assembly.