Touch select 2-4 and high-low system
Symptom
| Suspected Area
| See page
|
When the vehicle is in the 2WD state and the transfer position switch is turned to a position other than 2WD, the 4HI and 4LO indicator lights are not illuminated
| CAN communication system
|
Click here
|
Combination meter assembly
|
Transfer position switch (open circuit in LO terminal circuit or stuck OFF)
|
4 wheel drive control ECU
|
When the vehicle is in the 4H state and the transfer position switch is turned to a position other than 4H, the 4HI indicator light is illuminated and the 4LO indicator light is not illuminated
| Transfer position switch (short circuit in 2-4 or LO terminal circuit or stuck ON)
|
Click here
|
4 wheel drive control ECU
|
When the vehicle is in the 4L state and the transfer position switch is turned to a position other than 4L, the 4HI indicator light is not illuminated and the 4LO indicator light is illuminated
| Transfer position switch (open circuit in 2-4 terminal circuit or stuck OFF)
|
Click here
|
4 wheel drive control ECU
|
CAN communication system
|
The 4HI indicator light is blinking* after operation of the transfer position switch
| A.D.D. actuator (differential vacuum actuator assembly)
|
Click here
|
Transfer shift actuator assembly (transfer shift motor)
|
A.D.D. actuator (differential vacuum actuator assembly) (A.D.D. shift motor)
|
4 wheel drive control ECU
|
The 4LO indicator light is blinking* after operation of the transfer position switch
| Transfer shift actuator assembly (transfer shift motor)
|
Click here
|
4 wheel drive control ECU
|