Home › DRIVE LINE › WF1AM TRANSFER › 4WD CONTROL SWITCH

4WD CONTROL SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT INDICATOR LIGHT
  1. Inspect the 4HI Indicator Light:

    1. Start the engine.

    2. Change the 4WD control switch from 2WD to 4H.

    3. Check the 4HI indicator light.

      OK:
      The 4HI indicator light comes on or the 4HI indicator light comes on after it is blinking.

      If the result is not as specified, inspect the switch, four wheel drive control ECU and transfer shift actuator assembly.
      If there is a malfunction, inspect the switch, ECU, transfer shift actuator and A.D.D. actuator. If the system is normal, there may be a malfunction in the CAN communication system or combination meter. In this case, first check the CAN communication system (Click here). Then check the combination meter (Click here) and touch select 2-4 and high-low system (Click here).

  1. Inspect the 4LO Indicator Light:

    1. Start the engine.

    2. Move the shift lever to N.

    3. Change the 4WD control switch from 2WD to 4H. Then change it from 4H to 4L after the 4HI indicator light illuminates (after 4H switch completion).

    4. Check the 4LO indicator light.

      OK:
      The 4LO indicator light comes on or the 4LO indicator light comes on after it is blinking.

      If there is a malfunction, inspect the switch, ECU and actuator. If the system is normal, the combination meter may be malfunctioning.



2. INSPECT TRANSFER POSITION SWITCH
  1. Remove the transfer position switch with its connector still connected (See page TF-89).



    C291352E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J129-2 (2-4) - Body ground
    Ignition switch ON
    2WD position
    Below 1 V
    Ignition switch ON
    4H position
    Below 1.5 V
    Ignition switch ON
    4L position
    10.5 to 14 V
    J129-3 (LO) - Body ground
    Ignition switch ON
    2WD position
    10.5 to 14 V
    Ignition switch ON
    4H position
    Below 1.5 V
    Ignition switch ON
    4L position
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Transfer Position Switch)