POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > All Power Windows does not Operate with Door Key Cylinder |
| 1.CHECK LIN COMMUNICATION SYSTEM |
Check for LIN communication system DTCs related to the power window control system.
|
| ||||
| OK | |
| 2.CHECK FOR DTC (B2312) |
Check if DTC B2312 is output (Click here).
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (DOOR LOCK SWITCH) |
Use the Data List to check if the door lock switch is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Door Key SW-Lock | Door key linked lock switch signal / ON or OFF | ON: Driver side door key cylinder is turned to lock position OFF: Driver side door key cylinder is not turned | - |
| Door Key SW-Unlock | Door key linked unlock switch signal / ON or OFF | ON: Driver side door key cylinder is turned to unlock position OFF: Driver side door key cylinder is not turned | - |
|
| ||||
| OK | |
| 4.CHECK POWER WINDOW MANUAL FUNCTION |
Check that the manual UP/DOWN function using the master switch can operate the front door power window LH and RH (Click here).
|
| ||||
| OK | ||
| ||