Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise SET Indicator Light Circuit

for Preparation Click here


DESCRIPTION

When the ECM detects a cruise control main switch "on" signal from the cruise control main switch, it sends it to the combination meter through CAN communication. Then the cruise control SET indicator light turns on.

INSPECTION PROCEDURE

NOTICE:
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.

1.PERFORM ACTIVE TEST USING TECHSTREAM (CRUISE CONTROL SET INDICATOR LIGHT)
  1. Using the Techstream, perform the Active Test (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. SET
    Cruise control SET indicator light
    ON/OFF
    -

    OK:
    Indicator light turns on/off.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.READ VALUE USING TECHSTREAM (CRUISE CONTROL MAIN SWITCH)
  1. Using the Techstream, read the Data List (Click here).

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    SET/COAST Switch
    -SET switch signal / ON or OFF
    ON: -SET switch on
    OFF: -SET switch off
    -

    OK:
    The display is as specified in the normal condition column.

Result 
Result
Proceed to
OK
A
NG (for 1UR-FE)
B
NG (for 1GR-FE)
C
NG (for 3UR-FE)
D
NG (for 3UR-FBE)
E


B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)

E
REPLACE ECM (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)