Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AB8    Destination Information Undefined

for Preparation Click here


DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (driver side junction block assembly) and destination information cannot be confirmed after a blind spot monitor has been replaced.

DTC Code
DTC Detection Condition
Trouble Area
C1AB8
The blind spot monitor sensor cannot communicate with the main body ECU (driver side junction block assembly).
  1. CAN communication system
  2. Main body ECU (driver side junction block assembly)
  3. Blind spot monitor sensor LH
  4. Blind spot monitor sensor RH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check for CAN Communication System DTCs (Click here).

    OK:
    CAN communication system DTCs are not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
  1. Replace the main body ECU (driver side junction block assembly) with a new or normally functioning one.


NEXT


3.CHECK DTC
  1. Recheck for DTCs and check if the same DTC is output again (Click here).
    Result 
    Result
    Proceed to
    No DTC is output
    A
    DTC is output from the blind spot monitor sensor RH (master)
    B
    DTC is output from the blind spot monitor sensor LH (slave)
    C



B
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)

C
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
A

END (MAIN BODY ECU [DRIVER SIDE JUNCTION BLOCK ASSEMBLY] IS DEFECTIVE)