DTC U1331 Software Incompatibility with Body Control Module "B" |
| DTC Code | DTC Detection Condition | Trouble Area |
| U1331 | Destination information of the main body ECU (driver side junction block assembly) and blind spot monitor sensor do not match. |
|
| 1.CONFIRM PART NUMBER (MAIN BODY ECU [DRIVER SIDE JUNCTION BLOCK ASSEMBLY]) |
Check the main body ECU (driver side junction block assembly) part number.
Check if the part number of the main body ECU (driver side junction block assembly) installed on the vehicle is correct.
|
| ||||
| OK | |
| 2.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
| No DTC is output | A |
| DTC is output from the blind spot monitor sensor RH (master) | B |
| DTC is output from the blind spot monitor sensor LH (slave) | C |
|
| ||||
|
| ||||
| A | ||
| ||