Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    U0232    Lost Communication with Blind Spot Monitor Slave Module

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH judges that there is a communication problem with the blind spot monitor sensor LH.

DTC Code
DTC Detection Condition
Trouble Area
U0232
The blind spot monitor sensor RH cannot receive signals from the blind spot monitor sensor LH.
  1. CAN communication Line
  2. Harness or connector
  3. Blind spot monitor sensor LH
  4. Blind spot monitor sensor RH

WIRING DIAGRAM


E233765E14


INSPECTION PROCEDURE

NOTICE:
  1. When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - BLIND SPOT MONITOR SENSOR LH)
  1. Disconnect the S6 blind spot monitor sensor RH connector.

  1. Disconnect the S5 blind spot monitor sensor LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S6-1 (CA2P) - S5-1 (CA2P)
    Always
    Below 1 Ω
    S6-6 (CA2N) - S5-6 (CA2N)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE CAN LINE OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - BATTERY AND BODY GROUND)


    E263038E25
  1. Disconnect the blind spot monitor sensor LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S5-5 (BLB) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S5-10 (BLGD) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Blind Spot Monitor Sensor LH)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK BLIND SPOT MONITOR SENSOR LH
  1. Replace the blind spot monitor sensor LH with a new or normally functioning one (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)
OK

END (BLIND SPOT MONITOR SENSOR LH IS DEFECTIVE)