Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1A45    Vehicle Speed Sensor

for Preparation Click here


DESCRIPTION

The blind spot monitor sensor receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication.

DTC Code
DTC Detection Condition
Trouble Area
C1A45
A fail flag is transmitted from the skid control ECU (brake actuator assembly).
  1. Vehicle stability control system
  2. Blind spot monitor sensor LH
  3. Blind spot monitor sensor RH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for vehicle stability control system DTCs (Click here).

    OK:
    Vehicle stability control system DTCs are not output.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
OK


2.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).
    Result 
    Result
    Proceed to
    No DTC is output
    A
    DTC is output from the blind spot monitor sensor RH (master)
    B
    DTC is output from the blind spot monitor sensor LH (slave)
    C



B
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)

C
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)