Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1AC2    Slave Module Horizontal Axis Misalignment

for Preparation Click here


DESCRIPTION

This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis.

HINT:
If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch assembly (warning canceling switch assembly) on, the blind spot monitor system may store this DTC by mistake.


DTC Code
DTC Detection Condition
Trouble Area
C1AC2
When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated.
Blind spot monitor sensor LH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

1.CHECK INSTALLATION CONDITION
  1. Check the installation condition of the blind spot monitor sensor LH (Click here).

    HINT:
    Take the appropriate action in accordance with the result.


NEXT


2.PERFORM BEAM AXIS CONFIRMATION
  1. Install the rear bumper (Click here).

  1. Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream (Click here).

    OK:
    Blind Spot Monitor Beam Axis Confirmation performs normally.



NG
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
OK

END