Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

DTC    P17A8    Transfer Shift Motor Control Circuit Circuit Open

DTC    P17A9    Transfer Shift Motor Control Circuit Low

for Preparation Click here


DESCRIPTION

This DTC is detected when an open circuit or short to ground is detected in the transfer shift motor drive circuit.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
P17A8
  1. Ignition switch ON (when transfer shift motor is not operating)
  2. Open circuit in the transfer shift motor drive circuit
  3. 1 second or more
  4. 1 trip detection logic
  1. Wire harness and connector
  2. 4 wheel drive control ECU
  3. Transfer shift actuator assembly
P17A9
  1. Ignition switch ON (when transfer shift motor is not operating)
  2. Short to ground in the transfer shift motor drive circuit
  3. 1 second or more
  4. 1 trip detection logic
  1. Wire harness and connector
  2. 4 wheel drive control ECU
  3. Transfer shift actuator assembly

WIRING DIAGRAM


C290925E02


INSPECTION PROCEDURE

1.CHECK TRANSFER SHIFT ACTUATOR ASSEMBLY (TRANSFER SHIFT MOTOR)
E116654E18
  1. Disconnect the 4 wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A26-1 (TM1) - A26-2 (TM2)
    Always
    Below 5 Ω
    A26-1 (TM1) or A26-2 (TM2) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to 4 Wheel Drive Control ECU)



NG
Go to step 2
OK

REPLACE 4 WHEEL DRIVE CONTROL ECU (Click here)  

2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - TRANSFER SHIFT ACTUATOR ASSEMBLY)
  1. Disconnect the A26 4 wheel drive control ECU connector.

  1. Disconnect the D67 transfer shift actuator assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A26-1 (TM1) - D67-1 (TM1)
    Always
    Below 1 Ω
    A26-2 (TM2) - D67-2 (TM2)
    Always
    Below 1 Ω
    A26-1 (TM1) or D67-1 (TM1) - Body ground
    Always
    10 kΩ or higher
    A26-2 (TM2) or D67-2 (TM2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY (Click here)