DTC P17AB Transfer Shift Motor Position Circuit |
| DTC Code | DTC Detection Condition
| Trouble Area |
| P17AB |
|
|

| 1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND TRANSFER SHIFT ACTUATOR ASSEMBLY - BODY GROUND) |
Disconnect the A26 4 wheel drive control ECU connector.
Disconnect the D68 transfer shift actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-18 (TL1) or D68-1 (TL1) - Body ground | Always | 10 kΩ or higher |
| A26-20 (TL2) or D68-2 (TL2) - Body ground | Always | 10 kΩ or higher |
| A26-26 (TL3) or D68-3 (TL3) - Body ground | Always | 10 kΩ or higher |
| A26-24 (TL4) or D68-4 (TL4) - Body ground | Always | 10 kΩ or higher |
| A26-22 (GTL) or D68-5 (GTL) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT TRANSFER SHIFT ACTUATOR ASSEMBLY (LIMIT SWITCH) |
![]() |
Disconnect the D68 transfer shift actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (TL1) - Body ground | Always | 10 kΩ or higher |
| 2 (TL2) - Body ground | Always | 10 kΩ or higher |
| 3 (TL3) - Body ground | Always | 10 kΩ or higher |
| 4 (TL4) - Body ground | Always | 10 kΩ or higher |
| 5 (GTL) - Body ground | Always | 10 kΩ or higher |
| *a | Component without harness connected (Transfer Shift Actuator Assembly) |
|
| ||||
| OK | ||
| ||