Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

DTC    P17AA    Transfer Shift Motor Control Circuit High

for Preparation Click here


DESCRIPTION

This DTC is detected when a short to B+ is detected in the transfer shift motor drive circuit.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
P17AA
  1. Ignition switch ON (when transfer shift motor is not operating)
  2. Short to B+ in the transfer shift motor drive circuit
  3. 1 second or more
  4. 1 trip detection logic
  1. Wire harness and connector
  2. 4 wheel drive control ECU
  3. Transfer shift actuator assembly

WIRING DIAGRAM

Refer to DTCs P17A8 and P17A9 .

INSPECTION PROCEDURE

1.CHECK TRANSFER SHIFT ACTUATOR ASSEMBLY (TRANSFER SHIFT MOTOR)
E116654E18
  1. Disconnect the 4 wheel drive control ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A26-1 (TM1) or A26-2 (TM2) - Body ground
    Ignition switch ON
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to 4 Wheel Drive Control ECU)



NG
Go to step 2
OK

REPLACE 4 WHEEL DRIVE CONTROL ECU (Click here)  

2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND TRANSFER SHIFT ACTUATOR ASSEMBLY - BODY GROUND)
  1. Disconnect the A26 4 wheel drive control ECU connector.

  1. Disconnect the D67 transfer shift actuator assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A26-1 (TM1) or D67-1 (TM1) - Body ground
    Ignition switch ON
    Below 1 V
    A26-2 (TM2) or D67-2 (TM2) - Body ground
    Ignition switch ON
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY (Click here)