Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Display Signal Circuit between Radio Receiver and Extension Module

for Preparation Click here


DESCRIPTION

The stereo component tuner assembly sends the sound data signal or image data signal from a device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM


E280906E06


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SATELLITE RADIO TUNER ASSEMBLY)
  1. Disconnect the K5 and L2 radio and display receiver assembly connectors.

  1. Disconnect the K2 and L3 stereo component tuner assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K5-1 (USV4) - K2-1 (USV4)
    Always
    Below 1 Ω
    K5-2 (US4-) - K2-2 (US4-)
    Always
    Below 1 Ω
    K5-3 (US4+) - K2-3 (US4+)
    Always
    Below 1 Ω
    K5-4 (UGD4) - K2-4 (UGD4)
    Always
    Below 1 Ω
    K5-5 (USG4) - K2-5 (USG4)
    Always
    Below 1 Ω
    L2-4 (+B2) - L3-4 (+B2)
    Always
    Below 1 Ω
    L2-3 (ACC2) - L3-3 (ACC2)
    Always
    Below 1 Ω
    L2-8 (GND2) - L3-8 (GND2)
    Always
    Below 1 Ω
    K5-1 (USV4) - Body ground
    Always
    10 kΩ or higher
    K5-2 (US4-) - Body ground
    Always
    10 kΩ or higher
    K5-3 (US4+) - Body ground
    Always
    10 kΩ or higher
    K5-4 (UGD4) - Body ground
    Always
    10 kΩ or higher
    K5-5 (USG4) - Body ground
    Always
    10 kΩ or higher
    L2-4 (+B2) - Body ground
    Always
    10 kΩ or higher
    L2-3 (ACC2) - Body ground
    Always
    10 kΩ or higher
    L2-8 (GND2) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPAIR OR REPLACE NO. 1 NAVIGATION WIRE (Click here)

C
REPAIR OR REPLACE NO. 1 NAVIGATION WIRE (Click here)
A


2.CHECK NO. 1 NAVIGATION WIRE (LVDS COMMUNICATION LINE)
  1. Replace the No. 1 navigation wire with a known good one.

    1. for Column Shift Type: See page
    2. for Floor Shift Type: See page

  1. Check that the malfunction disappears.

    OK.:
    Malfunction disappears



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (NO. 1 NAVIGATION WIRE [LVDS COMMUNICATION LINE] IS DEFECTIVE)