DTC P2109 Throttle / Pedal Position Sensor "A" Minimum Stop Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2109 | The ISC learned value is approximately 3 times larger than normal even though the actual intake air amount during idling is within the normal range (up to 1.5 times the normal amount) (5 trip detection logic) | Throttle body assembly |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO P2109) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| Only DTC P2109 is output | A |
| DTC P2109 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK FREEZE FRAME DATA |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Using the Techstream, check "ISC Learning Value" in the freeze frame data (Click here).
| NEXT | |
| 3.REMOVE FOREIGN OBJECT (CLEAN THROTTLE BODY ASSEMBLY) |
![]() |
Clean off any deposits from the inside of the throttle body.
Push open the throttle valve and wipe off any carbon from the valve and bore using a cloth soaked in non-residue solvent.
| NEXT | |
| 4.READ VALUE USING TECHSTREAM (ISC LEARNING VALUE) |
Perform "Inspection After Repair" after cleaning or replacing the throttle body assembly (Click here).
Enter the following menus: Powertrain / Engine and ECT / Data List / ISC Learning Value.
Read the value.
|
| ||||
| OK | ||
| ||