Home › Engine / Hybrid System › 1UR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM27M0U _51 Engine / Hybrid System _049093 1UR-FE ENGINE CONTROL _0233893 ACCELERATOR PEDAL A

1UR-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ACCELERATOR PEDAL ROD ASSEMBLY

NOTICE:
·

Avoid physical shocks to the accelerator pedal rod assembly.

·

Do not disassemble the accelerator pedal rod assembly.

·

This accelerator pedal does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal rod assembly.

If applied, the accelerator pedal rod assembly must be replaced.



a.
A153493

Install the accelerator pedal rod with the 2 nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.

Connect the accelerator pedal position sensor connector.