1UR-FE ENGINE CONTROL
SFI SYSTEM
- PRECAUTION
- DEFINITION OF TERMS
- PARTS LOCATION
- SYSTEM DIAGRAM
- HOW TO PROCEED WITH TROUBLESHOOTING
- CHECK FOR INTERMITTENT PROBLEMS
- BASIC INSPECTION
- REGISTRATION
- INITIALIZATION
- CHECKING MONITOR STATUS
- READINESS MONITOR DRIVE PATTERN
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECM
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FREEZE FRAME DATA
- CHECK MODE PROCEDURE
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- P0010, P0020
- P0011, P0012, P0021, P0022
- P0013, P0023
- P0014, P0015, P0024, P0025
- P0016, P0017, P0018, P0019
- P0031, P0032, P0051, P0052, P101D, P103D
- P0037, P0038, P0057, P0058, P0141, P0161, P102D, P105D
- P006A After the engine is warmed up and the engine is idled for 30 seconds or more, the intake manifold pressure...
- P0101 Conditions (a), (b), (c), (d) and (e) continue for more than 10 seconds (2 trip detection logic): (a) Engine...
- P0102, P0103
- P0107, P0108
- P0111 When either condition below is met: (2 trip detection logic) 1. The intake air temperature change from the...
- P0112, P0113
- P0115, P0117, P0118
- P0116 When either of following conditions met (2 trip detection logic): · When cold engine started and engine...
- P011B All of the following conditions are met (2 trip detection logic): 1. The battery voltage is 10.5 V or higher....
- P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135
- P0125 Engine Coolant Temperature (ECT) does not reach closed-loop enabling temperature for 20 minutes (this period...
- P0128 Conditions (a), (b) and (c) met for 5 seconds (2 trip detection logic): (a) Cold start (b) Engine warmed up...
- P0136, P0137, P0138, P0139, P013A, P013C, P0156, P0157, P0158, P0159
- P014C, P014D, P014E, P014F, P015A, P015B, P015C, P015D
- P0171, P0172, P0174, P0175
- P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308
- P0327, P0328, P032C, P032D, P0332, P0333, P033C, P033D
- P0335, P0337, P0338, P0339
- P0340, P0342, P0343, P0345, P0347, P0348
- P0351, P0352, P0353, P0354, P0355, P0356, P0357, P0358
- P0365, P0367, P0368, P0390, P0392, P0393
- P0401 Change in intake manifold pressure is small when the EGR valve is opened and closed during idle fuel cut...
- P0403 Open or short in EGR valve circuit (1 trip detection logic)
- P0412, P0415
- P0418, P0419
- P0420, P0430
- P043E, P043F, P2401, P2402, P2419
- P0441 Leak detection pump creates negative pressure (vacuum) in EVAP system and EVAP system pressure measured....
- P0451, P0452, P0453
- P0455, P0456
- P0500 While vehicle being driven, no vehicle speed sensor signal transmitted to ECM (2 trip detection logic)
- P0504 Conditions (a), (b) and (c) continue for 0.5 seconds or more (1 trip detection logic): (a) Ignition switch ON...
- P0505 Idling speed continues to vary greatly from target idling speed (2 trip detection logic)
- P050A Insufficient mass air flow at cold start (2 trip detection logic)
- P050B Insufficient ignition timing retard at cold start (2 trip detection logic)
- P0550, P0552, P0553
- P0560 Open in ECM back up power source circuit (1 trip detection logic)
- P0604 ECM RAM errors (1 trip detection logic)
- P0606 When either condition below is met: · ECM main CPU error · ECM sub CPU error (1 trip detection logic)
- P0607 Either condition is met: · ECM CPU malfunction · HO2S transistor malfunction (1 trip detection logic)
- P060A When any condition below is met: · ECM main CPU error · ECM sub CPU error · Electronic throttle monitoring...
- P060B ECM main CPU communication error (1 trip detection logic)
- P060D When either condition below is met: · ECM main CPU error · ECM sub CPU error (1 trip detection logic)
- P060E When either condition below is met: · ECM main CPU error · ECM sub CPU error (1 trip detection logic)
- P0617 When conditions (a), (b) and (c) met, positive (+B) battery voltage of 10.5 V or more applied to ECM for 20...
- P062F An ECM internal error (EEPROM). (1 trip detection logic)
- P0630 When either condition below is met: (1 trip detection logic) · VIN not stored in ECM · Input VIN incorrect
- P0657 Throttle actuator power supply error (1 trip detection logic)
- P0724 Stop light switch remains ON even when vehicle is driven in GO (30 km/h (18.63 mph) or more) and STOP (less...
- P106A, P106B
- P1340, P1342, P1343
- P144C, P144D
- P1603, P1605
- P1604 Either condition is met: · The engine speed is below 500 rpm with the STA signal on for a certain amount of...
- P1607 ECM CPUs malfunction (1 trip detection logic)
- P1613, P1614
- P2102, P2103
- P2109 The ISC learned value is approximately 3 times larger than normal even though the actual intake air amount...
- P2111, P2112
- P2118 Open in ETCS power source (+BM) circuit (1 trip detection logic)
- P2119 Throttle valve opening angle continues to vary greatly from target opening angle (1 trip detection logic)
- P2120, P2122, P2123, P2125, P2127, P2128, P2138
- P2121 Either conditions (1) or (2) met for 0.5 seconds (1 trip detection logic): (1) Difference between VPA and...
- P2195, P2196, P2197, P2198
- P219A, P219B, P219C, P219D, P219E, P219F, P21A0, P21A1, P21A2, P21A3
- P2237, P2238, P2239, P2240, P2241, P2242, P2252, P2253, P2255, P2256
- P2420 Following condition met during key-off EVAP monitor: · EVAP pressure change when vent valve closed (ON) less...
- P2431, P2432, P2433, P2436, P2437, P2438
- P2440, P2441, P2442, P2443
- P2444, P2445, P2446, P2447
- P2610 ECM internal malfunction (2 trip detection logic)
- EVAP System
- ECM Power Source Circuit
- VC Output Circuit
- Fuel Pump Control Circuit
- Fuel Injector Circuit
- Cranking Holding Function Circuit
- ACIS Control Circuit
- Brake Override System
- MIL Circuit
CAMSHAFT OIL CONTROL VALVE
THROTTLE BODY
ECM
ACCELERATOR PEDAL
MASS AIR FLOW METER
CAMSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR
ENGINE COOLANT TEMPERATURE SENSOR
KNOCK SENSOR
MANIFOLD ABSOLUTE PRESSURE SENSOR
AIR FUEL RATIO SENSOR
HEATED OXYGEN SENSOR
POWER STEERING OIL PRESSURE SWITCH
EFI RELAY
IGNITION RELAY NO. 2
FUEL PUMP RELAY
A/F SENSOR HEATER RELAY
VVT SENSOR