1.REMOVE INTEGRATION RELAY
2.INSPECT INTEGRATION RELAY (EFI)
Some relays are built into the integration relay. The integration relay cannot be disassembled. If there is a malfunction in the circuit of the integration relay, replace the integration relay.
The internal circuit of the integration relay is as shown in the illustration below. Inspect the integration relay using the following procedures.
Measure the resistance of the EFI No. 1 fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| EFI NO. 1 fuse | Always | Below 1 Ω |
If the result is not as specified, replace the EFI No. 1 fuse.
Measure the resistance of the EFI relay.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1C-1 - 1B-4
1C-1 - 1B-5 |
When battery voltage is not applied to terminals 1B-2 and 1B-3 | 10 kΩ or higher |
| When battery voltage is applied to terminals 1B-2 and 1B-3 | Below 1 Ω |
If the result is not as specified, replace the integration relay.
3.INSTALL INTEGRATION RELAY