The procedures should be performed by at least 2 people.
Wear protective gloves when removing the exhaust pipe assembly.
The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
Confirm that the exhaust pipe assembly has cooled down before removing it.
37117
1.REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD)
37140
2.REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)
17450B
3.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
17410
4.REMOVE FRONT EXHAUST PIPE ASSEMBLY
89465
5.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
Using SST, remove the heated oxygen sensor.
89465
6.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
Using SST, remove the heated oxygen sensor.